Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Maintenance And Storage; Ordering Replacement Parts - Hurricane HMH 200 Manual De Instrucciones Original

Anleitung_HMH_200_SPK7:_
GB

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.

8.1 Maintenance and storage

Clean the machine regularly. This will help to
keep
the machine in good working order and is the
basis for a long working life.
Keep the vent slots clean while you work.
Clean the plastic body and other plastic parts
with
a mild household cleaning agent and a damp
cloth. Do not use any aggressive agents or
solvents for cleaning purposes.
Never clean the shredder by spraying with water.
Prevent water getting inside the machine at all
cost.
Check the chassis securing screws from time to
time to ensure that they are tight.
If you do not intend to use the shredder for a
lengthy period, protect it from corrosion using
environmentally friendly oil.
Store the device in a dry room.
Store the device out of reach of children.
When you have finished your work, pull the
loading funnel forwards and clean the inside.
Use a brush to remove deposits from metal parts
on the inside. Apply a thin coating of oil to the
cleaned blade plate and blades.
When you close the loading funnel, make sure
that the safety switch and the release screw are
clean.
8.2 Replace, sharp and change blades
The blades on the blade plate are replaceable. If you
have to replace any blade, you must only use
genuine blades to ensure that they meet the relevant
quality and safety criteria.
Please note: For safety reasons we recommend that
you have all sharpening and blade replacement work
carried out by a specialist workshop.
14
05.11.2009 9:22 Uhr Seite 14
Always wear heavy duty working gloves
Undo the fastening nut (Figure 12a/Item B)
Undo the eight Philips screws (Figure 12b/Item C)
and remove the cover plate
Secure the rotary disk so that it cannot rotate (for
example by jamming it with a screwdriver, see
Figure 12c)
Undo the four blade screws (Figure 12c/Item D)
and remove the blades (Figure 12c/Item E)
Each of the blades can be turned once as they
are ground sharp on both ends. Then they must
be replaced by new blades.
To assemble, proceed in reverse order.

8.3 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.