Removing The Front And Top Fascia; Cleaning The Dust Filters; Connecting The Fan Controller; Installing The Front I/O Connectors - Corsair CARBIDE 600 Serie Guia De Instalacion

CARBIDE SERIES

8. Removing the Front and Top Fascia

From inside the case, carefully
push the tabs securing the
front or top to the case,
and pull gently outwards.
Repeat for all six (6) tabs for
the front panel or eight (8)
tabs for the top panel.
To replace panels, simply press
them back into place slowly.

9. Cleaning the Dust Filters

Remove the bottom dust
filter as shown, clean it with
compressed air, and then
replace.
Remove the front fascia,
remove the front dust filter,
clean it with compressed air,
and then replace.
13
600
®
600C_600Q STEP8

10. Connecting the Fan Controller

1. Connect the SATA power
connector to the PSU SATA
1
power cable.
2. Connect the 3 or 4-Pin fan
connecter to the case fan
header.
3. Push the fan speed selector
button on your case to
2
toggle fan speed.
3

11. Installing the Front I/O Connectors

See your motherboard's
manual for front panel header
locations and pin-outs.
USB 3.0
USB 2.0
HD AUDIO
HDD LED
POWER SW POWER LED –
RESET SW
POWER LED +
14