Craftsman 316.791900 Manual Del Operador página 4

CRAFTSMAN FU LL WAR RANTY
If this Craftsman product fails due to a defect in material or workmanship within two years from the date of purchase, return it to any Sears
store, Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).
This warranty applies for only 90 days from the purchase date if this product is ever used for commercial or rental purposes.
This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
• Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
• Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
On/Off Stop Control APPLiCATiONS
Fuel Cap As a trimmer:
Starter • Cutting grass and light weeds.
Rope Grip • Edging
• Decorative trimming around trees, fences, etc.
Other optional accessories may be used with this unit.
Shaft Grip
, Throttle Control
D-Handle
Spark Plug
Muffler
Air Filter/ Shaft Housing
Muffler Cover
Convertible
TM
Primer Bulb Coupler
Trimmer Attachment
Cutting Shield
J
Hassle Free<"> Plus Cutting Head
iNSTALL AND ADJUST THE D-HANDLE
Install Shaft Grip
1. Place D-handle over the T
shaft housing and onto _
T
the bottom clamp (Fig. 1).
Place it a minimum of 6
inches (15.24 cm) from
the end of the shaft grip.
2. Start screws with a flat-
head or T-25 Torx
screwdriver. Do not
tighten until handle is Fig. 1
adjusted.
Minimum 6 in.
(15.24 cm)
Screws
Clamp
Adjust
3. While holding the unit in the operating position (Fig. 8), position
the D-handle to the location that provides you the best grip.
4. Tighten the clamp screws evenly until the D-handle is secure.
INSTALLING THE TRIMMER ATTACHMENT
Prior to use, make sure trimmer attachment is installed correctly.
Please refer to Operating the Convertible
TM
Coupler System for
proper installation.
NOTE: Remove red cap or hanger from lower shaft housing prior to
assembling to Convertible
TM
coupler