DeLonghi Pinguino PAC 75U Instrucciones De Uso página 9

F75 USA OK 19-11-2003 17:45
S e l e c t i n g f u n c t i o n s
AS AIR CONDITIONER
With the unit turned off, the function selectori
12
is in the "O" position. To turn the unit on in
air conditioning mode, proceed as follows:
1. Rotate the function selector knob clockwi-
se:
• Place the large crystal symbol
with the reference mark to operate the
unit in air conditioning mode at maximum
fan speed.
• Place the small crystal symbol
with the reference mark to operate the
unit in air conditioning mode at minimum
fan speed.
2. Now set the required temperature by rota-
ting the room thermostat knob.
Note
The temperature is not expressed in degrees.
We therefore recommend rotating the room
14
thermostat knob
position. When room temperature has rea-
ched the required level, rotate the thermo-
stat knob slowly clockwise until the thermostat
is activated, turning the unit off. This programs
the unit to the precise level of comfort requi-
red which will then be automatically maintai-
ned by the thermostat with considerable
energy savings. When regulating the thermo-
stat, the air conditioning function is tempora-
rily interrupted and the unit continues to ope-
rate in fan only mode.
Pagina 9
in line
in line
to the maximum cool
AIR PURIFICATION WITH FAN
Your air conditioning unit has two special high
efficiency electrostatic 3M FILTRETE™ filters.
These filters, active in all modes, filter out
extremely fine particles (down to 0.01 thou-
sands of a inch).
If you want to purify the air by ventilating the
room only, rotate the function selector
anticlockwise.
• Place the large symbol
reference mark to operate the unit in air puri-
fication mode at maximum fan speed.
• Place the small symbol
reference mark to operate the unit in air puri-
fication mode at minimum fan speed.
TO TURN THE UNIT OFF COMPLETELY, SET
THE FUNCTION SELECTOR
POSITION AND UNPLUG FROM THE MAINS.
THIS UNIT EMPLOYS AN EXCLUSIVE CON-
DENSATION RECYCLING SYSTEM TO DISPO-
SE OF EXCESS MOISTURE.
IN NORMAL CONDITIONS, CONDENSA-
TION IS DISPOSED OF AUTOMATICALLY.
WHEN THE HUMIDITY IS PARTICULARLY
HIGH, AN EXCESS OF CONDENSATION
MAY BUILT UP IN THE TANK. WHEN THIS HAP-
PENS, THE INDI ATOR LIGHT
ON INDICATING THAT THE TANK SHOULD BE
EMPTIED. MAKE SURE THE TANK IS PUT BACK
CORRECTLY OTHERWISE THE LIGHT
REMAIN ON.
12
in line with the
in line with the
12
TO THE "O"
13 . COMES
13 WILL
9