RISCO Group VUpoint RVCM11W Guia De Instalacion página 16

11. Select a wireless network from the available list and click Connect.
NOTE – If your network is password protected, a password must be entered into
the displayed password screen.
12. Click Connect to establish the wireless connection (refer to Connecting to a
Wireless Network using the RISCO Cloud); the following success message is
displayed.
13. Once the "camera is ready for use" message is displayed, click Close. The
defined IP camera is displayed in the IP Cameras page.
NOTE – Once a wireless connection has been established, don't forget to
disconnect the IP camera Ethernet cable from the router.
Figure 10 List of available wireless networks
Figure 11 AP Network Password
Figure 12 Operation Completed
14