Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. Breakdowns
6.1 – The appliance is not working
Check whether there has not been a power cut.
Check whether the plug is energized.
6.2- The appliance is working but only becomes slightly cold
Check the thermostat programming.
Check whether the fan is working.
Check if there is any ice accumulation at the evaporator.
Check whether the door is properly closed.
6.3- Water appears at the bottom of the refrigerator
Check whether the emptying outlet is blocked or whether the emptying tube is not pointing towards the evaporation
tank in the compressor department.
Check whether the cabinet is level.
6.4 – The supplier cable is damaged
If the supply cord is damaged gets damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
6.5 – High Temperature Alarm (HI)
Check if there is any ice accumulation at the evaporator.
Check whether the fan is working .
Check whether the door was open for a long period of time.
6.6 – Low Temperature Alarm (LO)
Check the thermostat programming
If, after making these checks, the anomaly remains, you should ask your retailer for assistance or contact our
technical department directly.
In the latter case, you should indicate:
The nature of the failure, the number and type of the appliance and the purchase date (certificate of warranty).
The number and type of appliance is to be found on a plate situated inside the appliance, in the right-hand side part.
7. Dimensions:
Note : The internal fan don't shall be obstructed with foodstufs. These should not be put until to a height of 120 mm from
the ceiling. (load charge)
01.07.2016
Reference
X = Width (mm)
Z = Height (mm)
Y = Depth (mm)
Y
= Depth with open
1
door (mm)
Net weight (kg)
Gross weight (kg)
.
AP 600 PO / APA 600 PO
750
2000
755
1453
100
116
11
Publicidad
Tabla de contenido
