Facom DX.T10 Guía De Instrucciones página 15

6. The thermometer will continue measuring as long as the MEAS
button is pressed. When the button is released, the measurement
will be held in the display for 15-20 seconds.
7. When fi nished, remove the thermocouple from the sample, and
unplug the thermocouple from the meter. The thermometer will
shut OFF automatically after 15-20 seconds.
Note: IR measurements are active at the same time as the K t/c
measurements.
4.2.3 Setting the temperature scale : °C or °F
The temperature scale is displayed on the upper part of the
display.
To select the temperature scale:
°F: When the thermometer is OFF, hold down
°F will be displayed.
°C: When the thermometer is OFF, hold down
MEAS.
°C will be displayed.
The selected temperature scale will remain until changed by the user.
4.2.4 Continuous measurement
The user may want to leave the thermometer ON to measure over
an extended time period and not keep pressing the MEAS button.
To enter the continuous mode:
● When the thermometer is OFF, hold down the MODE button,
and then press MEAS. This will set the thermometer in the conti-
nuous mode. HOLD will not be displayed in the continuous mode
and the laser sighting will not run.
● When fi nished, press MEAS once. HOLD will be displayed and
the thermometer will shut down in 15-20 seconds. Alternatively,
press MEAS again to re-enter the continuous mode.
4.2.5 Operating method of the push buttons
● Centre (Yellow) Measurement Button - MEAS:
The centre button turns the thermometer ON and measures. The
thermometer measures temperature when this button is pressed
and held down.
When the button is released, it will automatically HOLD the
last reading on the display for a few seconds before the meter
automatically shuts OFF.
(HOLD) is displayed.
The thermometer will shut off in approx. 15-20 seconds. At
power-up the
thermometer returns to the last settings used.
● Mode Button:
Pressing this button makes the thermometer enter and advance
though several functions including some programmable functions.
The MODE button is used to select a specifi c function (i.e. MIN,
MAX) or to adjust an Alarm or the emissivity.
To enter the mode program, press MODE once. SET is displayed in
the lower right hand corner.
When pressed consecutively, it will scroll through the following
settings:
ε --> ε (Set) --> ALM Hi (Set) --> ALM Lo (Set) --> MAX --> MIN --> K --> ε
SET is displayed in the lower right hand corner of the display
NU-DX.T10_0906.indd Sec1:15 NU-DX.T10_0906.indd Sec1:15
and press MEAS.
and press
15
24/07/2007 14:55:24 24/07/2007 14:55:24