Pigro Felice MODUL'AIR Manual Del Usuario página 5

4. Ensure that adequate air pressure is maintained. After you inflate the furniture, you
should allow some time for the material to warm out. Once the product is warmed out,
you can pump more air to restore an optimal air pressure. As a result the creases, due to
folding, will disappear.
MAINTENANCE
1. Check the seams and valves regularly for tears.
2. Clean the device after each use with a garden hose; air dry thoroughly before storing the
item.
3. Do NOT attempt to clean with a power hose.
4. Do NOT use chemicals or solvents that may damage the device.
DEFLATING INSTRUCTIONS
1. Ensure the device is thoroughly clean and dry before deflating. IMPORTANT: Please read
the maintenance section.
2. Remove all accessories if applicable.
3. Open all air valves and deflate the device completely by pressing on the small valve knob
and twisting it 90°. You also have the option to use the reverse mode on the pump to fully
deflate the product.
4. Close the valve after the air is emptied from the product.
FOLDING / STORAGE
1. Fold the device properly; to do so, follow the drawing below.
TO START ALWAYS POSITION THE AIR VALVE FACING THE FLOOR
BASE
H TOP
8
HH TOP
2. Do not pack the product when wet; make sure the product has dried out completely
before packing.
3. Store the product in a clean place - that is indoors - at a room temperature between 10°C
(33 F), and 40°C (105 F); this can affect its functioning, which is not be covered under the
warranty.
REPAIR
Leak In The Device
The device comes with a repair patch. If you have an idea where the leak is, place a mixture
of dishwashing liquid and water into a spray bottle and spray over the suspicious areas. Any
leak will produce bubbles that will pinpoint the location of the leak. Thoroughly clean the
area surrounding the leak to remove any dirt or grime.
Use the provided repair patch to overlap the damaged area by approximately 1.5 cm (1/2").
Round off the edges and place the patch on the damaged area and press down firmly. You
may want to place a weight on top to keep the patch in place. Do NOT inflate the device
immediately after patching; wait at least one hour.
If the patch does not hold, you can purchase silicon or polyurethane based glue; the same
glue that is used for repairing camping mats, tents, or shoes. This product can be found in
your local shop or market. Use it to patch the device. Before doing so, please refer to the
instructions on glue and patching.
Device Not Inflating
• Always check to ensure that the hose is connected to the pump at AIR IN, inflating, and
not to AIR OUT. The AIR OUT connection is used to suck the product vacuum.
• When inflating, if air leaks from the nozzle, check to see if the nozzle is attached properly.
• If you use the product for long periods of time, there is a possibility that the chair
will start losing pressure after a while. This is normal. The air pressure in the product
fluctuates due to temperature changes. You can use the pump to restore air pressure in
the product.
Pump Not Working
Check to see if there is voltage on the socket by plugging in a different electrical appliance.
If the pump is plugged in, and the switch is turned on, the pump should be working. If this
is not the case, contact the Pigro Felice
®
Customer Service.
9