Okofen Pelletronic Touch Manual Del Usuario página 4

Remote control (Pelletronic Touch)
If your system is equipped with the weather-compensated heating controller Pelletronic Touch, you can provide each heating
circuit in your system with a remote control.
With the remote control you heat according to the measured room temperature to the adjustable set temperature.
The remote control should be mounted in the main room of the heating circuit on an inner wall. (not near of a heater, a
door or a window)
START UP REMOTE CONTROL
1 • Disconnect the power supply of the heating controller.
• Open the casing.
2 • Connect the bus cable.
Connector name
1
GND
2
3
• Set up the power supply of the heating controller.
3 Assignment of the heating circuits
• Press and hold the arrow key left / right for about 4
seconds until the LED
Now change the heating circuit number.
• The number of green LEDs top left corresponds to
the assigned heating circuit number. For example: 3
LED's shine,
With plus / minus you adjust the number of the LEDs.
• Press and hold the arrow keys again for about 4
seconds.
• Die LED
number was taken over. Afterwards the LED flashes
green. Wait until the green flashing has stopped!
Assign to all remote controls the corresponding heating
circuits.
Bus allocation
+24V
GND
A
B
flashes yellow.
heating circuit 3 is assigned!
shines yellow. The heating circuit