Operating The Remote Controller - Okofen Pelletronic Touch Manual Del Usuario

4 Periphery Learning
If the heating circles are assigned to all remote
controls, you must perform Periphery Learning on the
Touch operating device. After the periphery learning
the heating controller recognises all to the system
connected devices and sensors.
If a heating circuit disposes a remote control, is evident
by the Room temperature_actual in the measuring
value menu. A blank field appears when no remote
control with room sensor is in the system.

OPERATING THE REMOTE CONTROLLER

1
With plus / minus you adjust the room temperature by
+/-5°C.
The LED position shows the set value.
2
This LED may not shine nor flash during
operation!
If this LED flashes red, a problem exists with the bus
connection!
3 Use the arrows left / right to adjust the operating mode.
The LED position shows the set value.
Operating modes for Heating circuit:
Off
Auto
Set back
Heating
If no LED shines, you can not adjust the operation mode
of the heating circuit.
The operating mode system is Off or Domestic hot
water.
4 A red permanently shining of the status LED symbolizes
an error.