Craftsman 917.28033 El Manual Del Propietario página 31

d sonafiladas.
;uantes y porter
e hacen opera-
Ifreno frecuent-
3peraciones de
_a necesario.
asdeseguridad
esario°
t_libredeo!ras
marcha_ parala
I
b, r ea_
_,mirar adelante
3equeSos
: una pendiente
ntal.
_,archa baja de
_rarseo cambiar
_ren una pendi-
:ci6n,desconec-
lespacio cuesta
_tras va cuesta
_illas, porter la
Jespacio_
_S si no es neo-
y gradualmente
TROUBLESHOOTING CHART: _
See appropriate section in manual unlessdirected to. Sears service center
PROBLEM
Engine clicks but
will not start
Loss of power
Excessive vibration
t
2
3
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
2
3
1
Engine continues
to run when oper
- ator leaves seat
with attachment
clutch engaged
CAUSE
Weak or dead battery,
1
Corroded battery terminals,
Loose or damaged wiring,,
Faulty solenoid or starter.
Cutting too much grass/too fast,
Throttle in "CHOKE" position.
Build - up of grass, leaves and
trash under mower.
Dirty air filter.
Low oil level/dirty oil.
Faulty spark plug.,
Dirty fuel filter,
Stale or dirty fuel
Water in fuel,,
Spark plug wire loose.
Dirty engine air screentfins_
Dirty/clogged muffler, : i'
Loose or damaged wiring, ;
Carburetor out of adjustment.
Engine valves out of adjustment.
Worn, bent or loose blade,
Bent blade mandrel.
Loosetdamaged part(s),
Faulty operator - safety presence
control system. :
CORRECTION
Recharge or replace battery.
Clean batter'] terminals.
Check att wiring.
Check/replace solenoid or starter,,
Ra!se cutting height!reduce speed.
Adjust throttle control
C]dan underside of mower
housing,
Clean!replace air filter.
Check oil level/change oil.
Clean and regap ol change spark
plug.
RePlace fuel filter,
Empty fuel tank and refill tank with
fresh, clean gasoline.
Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
Connect/tighten spark plug wire.
Clean engine air screen/fins.
{
Clean!replace muffler.
Check all wiring,
See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
Replace blade_ Tighten blade bolt
Contact a Sears or other qualified
service center_
Tighten loose part(s), Replace
damaged parts.
Check wiring, switches and
connections, if not corrected,
contact a Sears or other qualified
service center,
31