Lindam LD166 Manual De Instrucciones página 7

LED REFERENCE TABLE
Light Colour Pattern
Baby Unit Solid Green
Link LED Solid Red
Flashing Green & Red
Baby Unit Solid Green
Power LED Flashing Green
Parent Unit Solid Green
Link LED Solid Red
Flashing Green and Red
Parent Unit Solid Green
Power LED Flashing Green
Flashing Green and Amber
Flashing Amber
RESET PROCEDURE - IF YOU CANNOT ESTABLISH A 'LINK'
If the link between the Units is broken at any time Link Indicator LEDs will glow red, and the Parent Unit will sound an alert
signal. If this occurs check that there is power to both Units, and that they are within range of one another. If you still cannot
establish a link use the following reset procedure.
NOTE: The reset procedure cannot be carried out if either Unit has a low battery.
1. Switch both of your units off (buttons (B) and (D) ) and position next to each other.
2. Starting with the nursery unit, switch it on and press and hold the (+) and (-) buttons (A)
simultaneously until you hear "beep beep" and the link light starts to flash green and red.
Release all buttons.
3. Press the (-) key 7 times until the link light turns solid red and you hear 'beep'.
4. Next turn on the parent unit. Simultaneously press and hold the (+) and (-) buttons (C) together until the red link light starts
flashing green and red and you hear "beep beep".
5. Finally repeat step 2 by pressing and holding the (+) and (-) keys on the Baby Unit until you hear " beep beep".
The units will now search for each other. Allow a few seconds for the link to reestablish and the link lights to turn green
again. Both units are now linked together.
Diagnosis
Link established
Link broken
Link resetting
Unit on and power level good
Unit on and batteries needs replacing
Link established
Link broken
Link resetting
Batteries charged
Unit on and power is low. Recharge batteries.
Unit is switched on and charging
Unit is switched off and charging
7
F