Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FAQs
What if the TurboTool ('Pet' edition only) is dirty or even blocked?
1.
Be sure to switch off the appliance and unplug it from the electrical
socket.
2. Pull the TurboTool from the telescopic extension tube or the hose handle.
3.
Actuate the release catches on either side as indicated (a) and lift the
cover (b).
4. Thoroughly clean the brush by hand. If you are unable to remove all dirt by
hand, use pincers or scissors.
IMPORTANT: When using these implements, always proceed with
extreme care. Make sure that the brushes and the V-belt are not damaged.
5. After cleaning, put the cover into place at the front first so that the four
recesses of the cover engage with the four tabs of the base (c).
6. Then shut the cover firmly (d). You should feel and hear it click into place.
Any other queries or concerns
•
Please make a note of the serial number and model number (see type plate on the bottom of the appliance)
before calling. Then call our Careline, see page 210 'International Service'.
Warranty
•
The statutory warranty regulations in accordance with the EU Directive 2011/83/EU apply.
•
In non-EU countries the minimum requirements of the warranty in the respective country apply.
Please do not send us your appliance,
unless you are sure that you cannot
solve the problem with our assistance
over the phone. You can reach us on:
see page 210 'International Service'
GB
b
a
d
c
27
Publicidad
Capítulos
Tabla de contenido
