Aux In Operation - LEXIBOOK RCD108 Series Manual De Instrucciones

Use the program function to preselect the order in which a sequence of tracks will be played.
Up to 20 tracks can be programmed.
1. Slide the FUNCTION switch to CD position and insert a disc or make sure the unit is not
playing a disc.
2. Press the PROGRAM button. The program sequence "01" will blink on the LED display
and the program indicator will blink as well.
3. Use SKIP FORWARDS or SKIP BACKWARDS to select the first track to include in the
programmed sequence.
4. Press PROGRAM to confirm and save the track.
5. Repeat steps 3 and 4 to program the other desired tracks.
6. Press PLAY to start playback. The tracks will be played in the programmed order.
7. Press STOP button once to stop playback, and press it twice to cancel the programmed
sequence. The program indicator will turn off once cancelled.
You can play music through the speakers of this Radio CD Player by connecting its AUX IN
jack to your MP3 or other digital audio player.
1. Plug one end of an audio cable (not included) into the AUX IN jack located at the back of
the unit, and the other end of the cable to the line out jack of the device you want to connect.
2. Slide the FUNCTION selector to the AUX position.
3. Adjust the VOLUME control to your desired listening level.
4. Use the function keys of your audio device to pause and resume the playback, adjust the
volume and select the next or the previous track.
5. To stop the music, remove the plug from the AUX IN jack.
Set the volume to lowest before connecting your headphone (not included) into the
headphone jack. Headphones should have a 3.5mm diameter stereo plug and an impedance
of 8 – 32 ohms. When headphones are connected, the speakers are automatically
disconnected.
Note:
Extended listening of music at high volume may damage your hearing. It is highly
recommended to use at comfortable volume levels.
RCD108seriesIM1486_V05_217.indd 17
CD PROGRAMMED PLAY

AUX IN OPERATION

HEADPHONE OPERATION
17 17
2/12/16 4:18 pm