Care And Cleaning - Petsafe PBC17-13465 Manual De Funcionamiento

B
Note: It is sometimes necessary to trim the
hair around the Contact Points to make sure
that contact is consistent.
4. Check the tightness of the Bark Control Collar by inserting one fi nger between a
Contact Point and the dog's neck (C). The fi t should be snug but not constricting.
5. Allow your dog to wear the collar for several minutes, then recheck the fi t. Check
the fi t again as your dog becomes more comfortable with the Bark Control Collar.

Care and Cleaning

• Your dog's neck and the Contact Points must be washed weekly with a damp cloth.
• Be sure that your pet's neck is thoroughly dry before placing the Bark Control
Collar back on his neck.
8
Do not shave the pet's neck as this may increase the risk
of skin irritation.
You should not make the collar any more tight than is
required for good contact. A collar that is too tight will
increase the risk of pressure necrosis in the contact area.
Risk of skin damage.
• For comfort, safety and effectiveness of this product,
please ensure that you check the fi t of your pet's collar
frequently. If any skin irritation is observed, discontinue
the use of the collar for a few days. If the condition
persists beyond 48 hours, see your veterinarian.
• Do not attach a lead to the collar. This can result in
pulling the Contact Points too tightly against your pet's
neck. Attach a lead to a separate, non-metallic collar
or harness, making sure the extra collar does not put
pressure on the Contact Points.
• Please refer to page 3 for additional information.
www.petsafe.net
C