Installation Check - Toto TS970C1 Manual De Instalación

■ Turn the water on for about a minute� Place a thermometer in the water
stream to confirm that the water temperature is at 104ºF (40ºC).
■ If the temperature is confirmed, rotate the temperature knob, without
pressing the button, counter-clockwise until it comes to the first stop.
Confirm that the temperature is about 108ºF (42ºC).
■ If the temperature is confirmed, press the knob button and rotate fully
counter-clockwise until it comes to a full stop. Confirm that the temperature
does noT exceed 120ºf (49ºC)�
■ Once confirmed, turn the knob back to 104ºF (40ºC) and confirm that
the temperature matches the knob setting�
■
NOTE: If any of the above temperature settings is not confirmed, repeat
the calibration procedure steps in "CalIBraTIng The valve" section�
Volume
Control
knob
Locking
Button
Temperature
Control Knob

inSTallaTion CheCk