Husqvarna 1365GN Manual Del Propietário página 11

Operation
RECEPTACLES
CAUTION
_:I P_tkv_ e* • • , " , m
NEVER attempt to power a device requiring more amperage
than generator or receptacle can supply.
DO NOT overload the generator. See"Don't Overload
Genera_r'.
120/240 Volt AC, 30 Amp, Locking
Receptacle
Use a N EMA LI4-30 plug with this receptacle. Connect a
4-wire cord set rated for 250 Volt AC loads at 30 Amps (or
greater) (Figure 7).You can use the same 4-wire cord if you
)lan to run a 120Volt load.
4-WireCord Set
/-
' (Neutral)
IPE_ _ 1[*TA_m
Y (Hot) | X (Hot)
NEMA L 14-30 /-_ Ground (Green)
This receptacle powers 1201240 Volt AC, 60 Hz, single
phase loadsrequiring up to 6,500 watts of power (6.5 kW)
at 30 Amps for 120Volts or 240Volts.The outlet is
protected by a push-to-reset circuit breaker.
120 Volt AC, 20 Amp, GFCI Duplex
Receptacles
Each duplex receptacle (Figure 8) is protected against
overload by a push-to-reset circuit breaker.
•l I
•l I
Use each receptacle to operate 120Volt AC, single-phase,
60 Hz electrical loadsrequiring up to 2,400 watts (2.4 kW)
at 20Amps of current. Use cord sets that are rated for
125Volt AC loads at 20 Amps (or greater).
12 Volt DC, I 0 Amp Receptacle
This receptacle (Figure 9) allows you to recharge a 12Volt
automotive or utility style storage battery with the battery
charge cables provided.
This receptacle can not recharge 6Volt batteries and can
not be used to crank an engine having a discharged battery.
See"Charging a Battery" on page9 before attempting to
recharge a battery.This outlet is protected by a l0 Amp
self-resetting circuit breaker.
I