Troubleshooting - Husqvarna 1365GN Manual Del Propietário

Troubleshooting
TROUBLESHOOTING
Problem
Engine is running, but no AC
output is available.
Cause
I. Circuit breaker isopen.
2. Poor connection or defective
cord set.
3. Connected device is bad.
Solution
I. Reset circuit breaker.
2. Check and repair.
.
4. Fault in generator. 4.
I. Short circuit in a connected load. I.
Engine runs good but bogs down
when loads are connected. 2. Generator is overloaded. 2.
3. Shorted generator circuit. 3.
I. Out of gasoline. I.
Engine shuts down during 2. Low oil level 2.
operation.
Engine lacks power. Load is too high. See
Connect another device that is in
good condition.
Contact local service facility.
Disconnect shorted electrical
load.
See "Don't Overload Generator".
Contact local service facility.
Fill fuel tank.
Fill crankcase to proper level or
place generator on a level surface.
"Don't Overload Generator".
m