Special Conditions - Binks PX1304-5 Manual De Servicio

EN
HAZARD
EXPLOSION STATIC ELECTRICITY
Use of this equipment in a
potentially explosive atmosphere.
Vapors from flammable liquids can
catch fire or explode from static
electricity discharges.
SPECIAL Over pressurization of equipment
CONDITIONS can cause equipment failure or
FOR SAFE USE injury.
REQUIRED
Use lubricating medium resistant
BY ATEX
to carburisation.
CERTIFICATION
Improper operation or
maintenance may create a hazard.
CAUSE
1. If installing this equipment in a potentially explosive
2. Check electrical continuity of the air supply to earth —
3. Electrically bond all metallic equipment to earth. Should
1. Do not exceed the stated maximum working pressures
2. Only a suitably approved static dissipating or conductive
3. Air supplies (compressors, etc.) shall be sited in a non-
4. Use lubricating medium resistant to carburisation and
5. User shall ensure all metallic parts of the equipment are
4 / 12
SAFEGUARDS
atmosphere, check the ATEX equipment category and
temperature ratings meet the requirements for the zoned
area.
should be no greater than 10
be no greater than 1 .
and motor speed as specified in this manual.
air supply hoses shall be attached to the equipment and
terminated to the air supply.
hazardous area with a filter on the air intake system to
prevent the ingress of dust or similar foreign material
into the parts where compression takes place.
has an auto ignition temperature of more than 185ºC for
T4 equipment.
suitably bonded to earth. Should be no greater than 1 .
6
.
77-3040-R1.2 (10/2014)