GE 20 Manual Del Propietario E Instalación página 18

Installation Instructions
INSTALLING THE REFRIGERATOR
(cont.)
[] REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location
or reversal of the handles - on some
models)
Stainless steel (on
some models):
O REMOVING
THE DOOR
HANDLE: Loosen
the set screws
with the 3/32"
Allen wrench
and remove
the handle.
NOTE: For
Double Door Mounting
models follow
Fasteners
the same
(appearance may vary)
procedure on
the oppositedoon
Badge
Plastic handle
(on some models):
@ REMOVING THE DOOR HANDLE: Depress the
tab on the underside of the handle and slide
the handle up and off of the mounting
fasteners.
Q REVERSING THE
DOOR HANDLE
(on some
models):
• Remove
the handle
mounting
fasteners with
a 3/16" Allen
wrench and
transfer
the handle
mounting
fasteners to
the right side.
Mounting
Fasteners
(appearance may vary)
-y
Badge
• Remove the logo badge.
• Remove and transfer the plug button to
the left side of the fresh food door. NOTE:
Use a flat plastic edge to prevent damaging
the door. Remove any adhesive on the door
with a mild detergent. Remove the paper
covering on the adhesive backing on
the logo badge prior to carefully attaching
the badge to the door.
18
[] REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:
O Loosen the set screws located on the
underside of the handle with the 1/8" Allen
wrench and remove the handle.
NOTE: If the handle mounting fasteners need
to be tightened or removed, use a 3/16" Allen
wrench.