Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Menu Map
The menu map shows the organization of the configuration settings. Use it for reference
when configuring the Net-X.
Main Function
Programming Levels
<Net>
<Subnet>
<Universe #1> to
<Universe #8>
ArtNet Input
sACN Input
<DMX Output #1>
to
DMX #1 Input
<DMX Output #8>
DMX #2 Input
Without Input
<IP Address #1>
x*.xxx.xxx.xxx
to
<IP Address #2>
<Device ID>
xxxxxxxxx
<Protocol>
<Net Mode>
<DMX Mode>
* - In Art-Net™ mode, the beginnings of the IP addresses are set by the Net setting, to
either:
·
2, for Net setting 0,
or
·
10, for Net setting 1.
* - In sACN mode, the beginnings of the IP addresses can be set to 2, 10, or 239.
Net-X User Manual Rev. 4
a
0–127
Sets the Net address
a
0–15
Sets the Subnet address
Sets the Art-Net™ universe for the corresponding DMX Out
a
0–15
port (only necessary when that DMX port is set to Art-Net™)
Sets the sACN universe for the corresponding DMX Out port
a
1–255
(only necessary when that DMX port is set to sACN)
a
Sets the input source for the DMX port to Art-Net™
a Sets the input source for the DMX port to sACN
a a Sets the input source for the DMX port to DMX In port 1
a a Sets the input source for the DMX port to DMX In port 2
a a Disables the DMX Out port
Sets the IP addresses for the Net-X
a a
Note: The addresses cannot be the same
a a Shows the Net-X device ID
a a Selects the Art-Net™ ethernet protocol
ArtNet
a a Selects the sACN ethernet protocol
sACN
a a Disables ethernet signal merging
OFF
a a Sets ethernet signal merging to Highest Takes Precedence
HTP
a a Sets ethernet signal merging to Latest Takes Precedence
LTP
a a Disables DMX signal merging
OFF
a a Sets DMX signal merging to Highest Takes Precedence
HTP
a a Sets DMX signal merging to Latest Takes Precedence
LTP
Configuration And Operation
Firmware V2.5
Description
Page 15 of 64
Publicidad
Tabla de contenido
