Craftsman 917.28812 Manual Del Operador página 24

2. Slide mower under tractor until it is
centered under tractor.
3. ATTACH MOWER SIDE SUSPEN-
SION ARMS (A) TO CHASSIS - Posi-
tion hole in arm over pin (B) on outside
of tractor chassis and secure with
washer and retainer spring.
_i_!ii!iiiii!i!ii
4. Repeat on opposite side of tractor.
5. ATTACH REAR LIFT LINKS (C) - Lift
rear corner of mower and position
slot in link assembly over pin on rear
mower bracket (D) and secure with
washer and retainer spring.
Repeat on opposite side of tractor.
8. Insert end of link (E) into hole in front
mower bracket (H) and secure with
washer and retainer spring (J).
9. Push clutch cable housing guide (P)
into bracket, slide collar (L) onto guide
and secure with retainer spring (K).
10. Hook end of clutch cable spring (Q)
into hole in idler arm (R).
11. Install belt onto engine clutch pulley (M).
.
7. ATTACH FRONT LINK (E) - Work from
left side of tractor. Insert rod end of link
assembly through front hole in tractor
front suspension bracket (F).
IMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
12. Raise attachment lift lever to highest
position.
13. If necessary, adjust gauge wheels
before operating mower as shown in
the Operation section of this manual.
24
03042 re×