Controls And Connections (Rear) - Bosch Plena Feedback Suppressor Manual De Instalación Y Funcionamiento

Plena Feedback Suppressor | Installation and Operating Manual |
1.3

Controls and connections (rear)

Mic 1/Line In
1 2 3
figure 1.3: Controls and connections (rear)
1 Microphone 1/Line input (XLR/balanced)
2 Microphone 1 input (5-pin DIN/balanced)
3 Mic/Line switch
The Mic/Line switch only affects Microphone 1/Line Input (1)
4 Microphone 2 input (XLR/balanced)
5 Microphone 2 input (5-pin DIN/balanced)
6 Line out (Cinch/unbalanced)
7 Line out (XLR/balanced)
8 Microphone level out (5-pin DIN/balanced). For connection to Plena Amplifiers only (see §3.1)
9 Signal level switch (see §3.1)
10 Options switches (see §3.2)
11 Earth connection screw
12 Mains fuse (T500 L 250V)
13 Mains connector (3-pole)
14 Mains voltage selection switch
15 Line in (Cinch/unbalanced)
16 Phantom power switch (microphone 1 and 2)
Switch that enables and disables phantom power on Microphone 1/Line input (1 and 2) and Microphone 2 input
(4 and 5). When the line input is selected with the help of the Mic/Line switch (3), phantom power is disabled for
this input.
Bosch Security Systems | 2003-11 | 9922 141 81681
16 15
Mic 2 In
On Off
Mic/Line
Phantom Mic 1+2
4 5
About the equipment
Line Line Out Mic Out
In
High Med. Low
Out
Signal Level
1 2 3 4
6 7 8 9
14
Switch On Off
1 Mode 2 Mode 1
115V~ 230V~
2 Dual input Auto mix Single input
(Mic1In + Mic 2) (Mic1/Line In)
3 Process with bass lift Process flat
4 Accurate mode Fast mode
LBB 1968/00 8900 196 80001 Apparatus delivered
connected for 230V-
Plena Feedback Suppressor
115/230V~,50/60Hz
N663
Rated input
S/N.
Design & Quality
Power: 50VA
The Netherlands
T500L250V
Warning
This apparatus must be earthed
10 11
en | 9
13
12