Tripp-Lite PS Serie Manual Del Propietário página 2

IMPORTANT SAFETY INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
WARNING
Use of this equipment in life support applications where failure of this
equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness
is not recommended. Do not use this equipment within oxygen-enriched
atmospheres, or within 0.3 m of a point at which an oxygen-enriched
atmosphere is intentionally vented.
CAUTION
DO NOT connect to an ungrounded outlet. DO NOT use with extension cords or
adapters that eliminate the connection to ground. The power strip is designed
for indoor use only. Install the power strip away from heat emitting appliances
such as radiators or heat registers. Do not install where excessive moisture
or other conductive contaminants are present. Never install electrical wiring
during a lightning storm.
Installation
1
Connect Your Power Strip to Your AC Power Line
Plug the power cord into a utility outlet. The power strip's power cord should only be connected
to a standard 3-wire grounded 120V AC 60 Hz outlet.
2
Connect AC Equipment to Your Power Strip
Plug the AC power cords of your equipment into your power strip. Do not use extension cords
or adapters that eliminate the connection to ground. DO NOT OVERLOAD your power strip. Each
outlet can handle a load of up to the model's amp rating, but do not exceed a total load of
more than the model's amp rating for all outlets. If the circuit breaker trips, outlets will cease to
provide power. Reduce the load on the power strip down to your unit's amp rating by unplugging
excess equipment, then depress the circuit breaker button to reset and restore power.
17-06-031-933707.indb 2
2
6/6/2017 8:52:52 AM