Assembly - Ninja COFFEE BAR CF087 Guia Del Usuario

Assembly

H
M
Fig. 4
Fig. 7
1
Place the brewer on a dry, clean and level surface.
2 Holding the water reservoir by the grip,
twist counterclockwise to remove. Either
flip the lid top over or remove lid by twisting
counterclockwise to remove. Fill with water up
to, but not exceeding the Clean Cycle Max
Fill line (30 oz.). To replace the water reservoir,
place on top of the base and twist clockwise
until a click indicates it is locked in place.
(Fig. 4)
3 Slide brew basket out and angle up slightly to remove it from
the brewer. (Fig. 5) To reinsert, align the brew basket with
the rails and slide back into the brewer. (Fig. 6)
Fig. 5
Fig. 8
H
M
OFF
Fig. 6
H
M
OFF
4 Once the brew basket is in place, slide all the way into place
until you hear a slight click.
5
Twist the brew-through lid clockwise onto the thermal carafe
to lock into place. (Fig. 7)
6 Center the thermal carafe below the brew basket. (Fig. 8)
NOTE: Do not use any coffee for the first two brew cycles in
order to clean the brewer.
7
Plug the brewer into an electrical outlet.
8 Once all parts are securely in place, press the Clean button to
thoroughly clean the machine before first use. (Fig. 9)
9 Discard the water in the carafe and repeat, beginning from
step 2, with one more clean cycle of water before first use.
OFF
Fig. 9
www.ninjacoffeebar.com
16