General Safety Information; Mounting The Illuminator - Dedicated Micros Dennard 2025 Manual Del Usuario

5. General Safety Information

This Dennard 2025 equipment shall only be installed by qualified service personnel.
The final installation must adhere to all national wiring regulations.
The disconnect device must comply with IEC 60947.
WARNING. Read instructions before installing and power up.
WARNING. Instructions should be kept for future reference.
WARNING. If this unit shows signs of damage or malfunction, disconnect from mains immediately
and contact Dennard LTD.

6. Mounting the Illuminator

Ensure the illuminator is mounted in a well ventilated area with over 100mm clearance around the
heatsink on all sides.
Avoid mounting the illuminator in direct sunlight or next to other heat sources.
Failure to provide this will shorten the life of the LEDs and decrease the lamp brightness.
WARNING: Ensure the illuminator is mounted a minimum of 2m away from eye level. Do not look
directly at the illuminator for prolonged periods during use.
2025 Installation Manual Page. 5