Publicidad
Idiomas disponibles
Idiomas disponibles
INSERTING BATTERIES
1. Unscrew the battery cover.
2. Insert 6 x 1.5V AA batteries. Re-
install the cover.
CHARGING THE VEHICLE
Attention: After each use, the battery
and the motor must cool down for 10
to 15 minutes.
1. Open the battery lock and remove
the battery.
2. Plug the charger into a standard AC
outlet and the charger base.
3. Plug the battery into the charger
base. The charger LED glows red to
show that charging is in progress.
When the LED turns off, the battery is
fully charged.
4. Unplug the charging unit and
remove the battery.
5. Re-insert the battery in the vehicle.
START
1. Press the ON/OFF button on the
controller; the LED illuminates.
2. Move the ON/OFF switch on the
vehicle to the "ON" position.
VEHICLE CONTROL
AND DRIVING TIPS
•
To slowly drive forward, pull the
trigger slightly. To drive faster, pull the
trigger further.
•
To brake, push the trigger. To drive in
reverse, push again.
•
To turn, rotate the wheel to the left or
right.
•
Always move the controls slowly and
with a gentle touch.
•
During a crash, release the trigger.
GEAR SHIFTING
Attention! Do not switch while the
motor is running!
1. Use low gear for indoors or large
inclines. Slide the lever to the left until it
locks.
2. Use high gear for open areas. Slide
the lever to the right until it locks.
STEERING RATE
The amount of steering throw can be
adjusted.
1. Turn the steering wheel full left and
hold.
2. Press the left trim button for more
throw and the right button for less
throw.
3
Publicidad
