Installation Instructions - GE GWS04 Manual Del Propietário

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
REMOVING THE PACKAGING
Before using the Wine Center/Beverage and Wine
Center, be sure all packing materials and tape have
been removed, including the protective film covering
the control and any film protecting the cabinet.
remove the doors to reduce the danger of children
being trapped inside.
INSTALLATION GUIDELINES
can be freestanding or can be installed under the
counter, with proper clearances.
installation, proper air circulation and electrical
connections:
source, let it stand upright for approximately
2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
Wine Center where the temperature will go below
temperature is below the temperature setting,
the Wine Center/Beverage and Wine Center will
Center where it will be subject to direct sunlight,
heat or moisture.
Models GVS04 and GWS04
BUILT-IN INSTALLATION
The cutout dimension shown, allows for door swing
needed on hinge side. The filler strip will act as a
spacer between the appliance case and adjacent
cabinet door swing. The width of the opening must
include the filler strip.
NOTE:
surrounding cabints.
Locate Outlet
6" Max.
152 mm Max.
33-1/2" Min.
851 mm Min.
19-1/2" Min.
495.3 mm Min.
LEVELING LEGS
Adjustable legs at the front corners of the Wine
Center/Beverage and Wine Center
should be set so the Wine Center/
Beverage and Wine Center is firmly
to the back to help the door closure.
To adjust the leveling legs, turn the
legs counterclockwise to raise the
beverage center/wine chiller, clockwise
to lower it.
23-1/2" Min
597mm Min.
19"
482.6 mm
19"
22-1/2"
495.3 mm
569 mm
including door
To raise the
appliance
33"
838 mm
49-60734-2