Setup; Power Requirements; Installing The Handle Bracket, Corner Safety Bumpers And Power Cord Manager; Adjusting Storage Shelf Dividers - Tripp-Lite CSCXS36AC Manual Del Propietário

4. Setup

Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack the charging station without assistance.
Follow the unpacking instructions document that shipped with this product before proceeding with setup. Use extreme caution
when handling the charging station and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the charging station.

4.1 Power Requirements

The charging station must be plugged into an AC outlet with a dedicated circuit.

4.2 Installing the Handle Bracket, Corner Safety Bumpers and Power Cord Manager

To install the handle bracket, choose a side on which to install the bracket (the same side as the cable access hole grommet and power cord manager
is recommended). Using the included hex key tool and four (4) hex screws, secure the handle bracket to the charging station cabinet
the two top corner safety bumpers using four (4) hex screws (two per bumper)
the same side as the cable access hole grommet
A
C

4.3 Adjusting Storage Shelf Dividers

Your charging station contains three non-removable storage shelves with adjustable
dividers.
To remove or rearrange the dividers, first open the rear door. Then push in the two tabs
securing the divider to the rear end
tray 2 , and pull out to remove
C .
1 , pull the divider up to disengage from the shelf
3 . Repeat as necessary for additional shelf dividers.
. To install the cord manager, use two (2) hex screws to secure on
B
B
3
5
. Then install
A
For illustrative purposes only.
2
Tray cannot be removed from
unit.
1