Setup; Power Requirements; Installing The Handle Bracket, Corner Safety Bumpers And Power Cord Manager - Tripp-Lite CSC42AC Manual Del Propietário

5. Setup

Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack the charging station without assistance.
Follow the unpacking instructions document that shipped with this product before proceeding with setup. Use extreme caution
when handling the charging station and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the charging station.

5.1 Power Requirements

The charging station must be plugged into an AC outlet with a dedicated circuit. An AC outlet with a 20-amp (NEMA 5-20R) AC circuit is recommended
for powering the charging station. The AC outlet used to power the charging station should not be shared. The total wattage of the charging station and
all connected components should not exceed 1440 watts.

5.2 Installing the Handle Bracket, Corner Safety Bumpers and Power Cord Manager

To install the handle bracket, choose a side on which to install the handle bracket (the same side as the cable access hole grommet and power cord
manager is recommended). Using the included hex key tool and four (4) hex screws, secure the handle bracket to the charging station cabinet
Then install the two top corner safety bumpers using four (4) hex screws (two per bumper)
secure on the same side as the cable access hole grommet
A
C
B
.
C
B
6
. To install the cord manager, use two (2) hex screws to
.
A