Wall Mounting; Desktop Placement - Tripp-Lite CSD32USB Manual Del Propietário

6. Wall Mounting

For wall mounting, you will need:
• Level
• Appropriate tools for wall mounting
• Appropriate hardware for wall mounting
(not included)
Warning: Do not attempt to mount the
charging station to the wall with any
personal electronic devices inside.
There are 4 keyhole cutouts on the charging
station cabinet's rear panel. Each keyhole can
accommodate an M5 or 3/16" bolt. The
keyhole sets are centered 16" apart horizontally
and 12" vertically A .
To mount the charging station, first remove the bottom shelf inside the cabinet
tape measure, measure to position your mounting area precisely. For the position where the top
keyholes will be located, secure appropriate fasteners (not included) to the wall or supporting
surface, then hang the charging station onto the hardware
use appropriate fasteners and the bottom keyhole slots to secure the charging station cabinet to
the wall .
D
Note: The charging station must be installed by a qualified technician. Use suitable mounting means when
installing to cinder block, concrete, drywall or wood studs. Warning: The supporting surface must be able to
safely support the combined load of the charging station, equipment stored and all attached hardware
and components. See Section 8. Specifications for more information on your model's weight and
dimensions.

7. Desktop Placement

14"
TOP
355.6 mm
2"
50.8 mm
2 13/16"
A
17.56 mm
WARNING: For desktop applications, always install the charging station in a structurally sound area
with a level surface that is able to bear the weight of the charging station, all equipment that will
be installed in the charging station and any other enclosures and/or equipment that will be installed
nearby. Never attempt to lift or install the charging station without adequate help. See Section
8. Specifications for more information on the charging station's rated load capacity.
For an added measure of security, the cabinet can secure to a desktop. There are two keyhole
cutouts located at the rear end of the bottom panel. Each keyhole can accommodate an M5 or
3/16" bolt. The bottom keyhole set is centered 18" (457 mm) apart horizontally and 14"
(356 mm) vertically from the front mounting holes
Using a tape measure, measure to position your mounting areas precisely. Use appropriate
fasteners (not included) to attach the cabinet to the rear keyhole cutouts
charging station to the desktop with the front mounting holes
TOP
16"
BOTTOM
A
C . For an added measure of security,
355.6 mm
50.8 mm
FRONT
18" 2 13/16"
457.2 mm 17.56 mm
.
A
B
.
C
6
12"
B
. Using a level and
B
14"
2"
18"
457.2 mm
and secure the
C
D
BOTTOM
FRONT
B
C
C
C
D
B