Publicidad
Enlaces rápidos
Mega
Installation Instructions
Instructions d'installation
Instrucciones de instalación
The Blue Diamond™ pump range out performs other condensate pumps, can be mounted in any
orientation and does exactly what you need it to do.
La gamme de pompes Blue Diamond™ dépasse les performances d'autres pompes de condensation, peut
être montée dans n'importe quelle orientation et fait exactement ce que vous attendez d'elle.
La serie de bombas Blue Diamond™ rinde más que otras bombas de condensado, se puede montar en
cualquier dirección y hace exactamente lo que usted necesita que haga.
TM
Manufactured by
www.charlesausten.com
Publicidad
Manuales relacionados para Charles Austen Blue Diamond Serie
Resumen de contenidos para Charles Austen Blue Diamond Serie
- Página 1 Mega Installation Instructions Instructions d’installation Instrucciones de instalación The Blue Diamond™ pump range out performs other condensate pumps, can be mounted in any orientation and does exactly what you need it to do. La gamme de pompes Blue Diamond™ dépasse les performances d’autres pompes de condensation, peut être montée dans n’importe quelle orientation et fait exactement ce que vous attendez d’elle.
- Página 2 Safety information Information de sécurité Precauciones de seguridad Warranty Garantie Garantía In the box Dans la boîte Material suministrado Mounting detail Notice de montage Acerca del montaje Continual running option Option fonctionnement continu Opción de funcionamiento continuo Installation Installation Instalación...
- Página 3 Reservoir option Option réservoir Opción de depósito DrainStik™ option Option DrainStik™ Opción de DrainStik™ Hot and cold sensor option Option sonde chaud et froid Opción Sensor frío y calor Water test Test eau ...
- Página 4 Note Page: Serial Number: Date of Install:...
- Página 5 Caution: Alarm lead must be connected to a class 2 circuit only – Do not connect to a load higher than 5A, 240v AC/DC. Caution: This pump has been evaluated for use with water only. Caution: Risk of electric shock: This pump has not been investigated for use in swimming pool or marine areas.
- Página 6 En el caso poco probable de un problema de funcionamiento dentro de 3 años a partir de la fecha de la compra y a pesar de un uso normal, Charles Austen Pumps se encarga sin coste alguno de la reparación o sustitución de la bomba bajo las siguientes condiciones:...
- Página 7 1. Pump (Mini, Maxi or Mega) 2. 2m (6’ 7”) mains lead 3. Zero volt alarm lead (reservoir and DrainStik™ only) 4. Sensor input socket 5. Sensing Option (a) Reservoir OR (b) Hot & cold sensor OR (c) DrainStik™ OR (d) Continuous Running Plug 6.
- Página 8 (inches) Mega Blue 9.21 Maxi Blue 5.59 Mini Blue 4.80 The pump may be mounted in any orientation but must be kept dry. La pompe peut être montée dans n’importe quelle orientation, mais doit être gardée sèche. La bomba se puede montar en cualquier orientación, pero se ha de mantener en seco. The continuous running (cooling signal) option allows the pump to run continuously.
- Página 9 G/hr Feet Feet Mini Blue 16.5 23.0 0.5A Maxi Blue 16.5 23.0 0.5A Mega Blue 13.2 23.0 66.5 1.0A Outlet / Drain Leave sufficient space around the pump unit to allow for cooling. Ensure that the pump is not more than A above the condensate outlet, and not more than B below the desired drainage point for the pump outlet.
- Página 10 Reservoir option/Option réservoir/ Opción de depósito <104°F Choose to use either the top IN and OUT or side IN and OUT connections and fit blanking plugs to the unused ports. Connect the reservoir outlet (...
- Página 12 DrainStik™ option / Option DrainStik™ / Opción de DrainStik™ <104°F Insert the sensor into the condensate tray pipe as shown and secure the hose in position. The DrainStik™ must be mounted vertically. Use the silicon hose provided. Insérez le capteur ...
- Página 14 Hot and cold sensor option / Option sonde chaud et froid / Opción Sensor frío y calor Position the hot thermistor sensor (red) in a suitable location at ambient air temperature. It is recommended that ceiling voids are avoided as these are usually at much higher temperatures. Place the cold thermistor sensor (blue) ...
- Página 16 The water test ensures that the pump responds to the water level & that the pump switches off when dry. To test, slowly pour cold water into the tray until the pump switches on. Allow the pump to run and switch off. The pump should run for approximately 20 seconds after emptying the reservoir/condensate tray pipe.
- Página 17 To ensure that the alarm connection is working, restrict the outlet of the reservoir/DrainStik™ hose and fill with water up to the high level sensor. The pump will turn on intially, then after a short delay the alarm relay will switch, detected using a multimeter or observing the shut down of the AC unit. Allow the water to exit the reservoir;...
- Página 18 If the pump is installed remotely, occasionally water can become trapped in the u-bend at the lowest point of the system. Due to the pump’s high flow rate, this can create a gurgling noise. It is recommended to fit the silencer supplied with the hot & cold sensor option. This must be fitted at the lowest point in the system, to reduce this noise.
- Página 19 Accessory Options MultiTank Product Code : C21-014 Mounting Feet Product Code : F10-011 16ft Extension Cable Product Code : C13-103...
- Página 20 4850 Golden Parkway, Suite B, 409 Buford, GA, 30518, USA Tel: +1 770 831 1122 Email: info@bluediamondpumps.com Web: www.bluediamondpumps.com Distributed by:- S30-195/3 Manufactured by www.charlesausten.com...