Troubleshooting; Cleaning And Maintenance - Lea LE20055 DN Instrucciones Originales

1. Disconnect the mains plug, Push the rotating knob(7) on the motor housing, and then
rotate the housing to the edge position. (Fig.8)
2. Push the edging knob button(6)) , and then turn the shaft clockwise , as you hear the 'click'
sound. (Fig.9)
3. Now the trimmer can be used as the edge cutter. (Fig.10)
10.AUTOMATIC LINE FEED
To lengthen the cutting wire:
Let the tool run idle at max. speed.
Release the switch.
Let the spool run until it stops. At the end you will hear a "click".
This will automatically lengthen the cutting wire by +/- 1 cm.
11. TROUBLE SHOOTING
PROBLEM
Line will not
advance
Cutting head is
hard to turn
Grass continually
wraps around the
shaft and teimmer
head assembly
Line trimmer
stops and will not
start again

12. CLEANING AND MAINTENANCE

Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance, switch off and unplug the tool.
Regularly clean the ventilation slot in your tool using a soft brush or dry cloth.
Regularly clean the cutting line and spool using a soft brush or dry cloth.
Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.
13. WARRANTY
This product is warranted for a 24-month period effective from the date of purchase by the
first user.
This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
POSSIBLE CAUSE
Line is welded to itself
Not enough line on the spool
Line has worn too short
Line is tangled on the spool
Grass wrapped or built up around
head
Cutting tall grass at ground level
Unit failed
Plug is damaged
15
SOLUTION
Lubricate with a silicone spray
Replace the spool
Remove the spool and feed
line out
Remove line from spool and
rewind
Clean the effected parts of the
machine
Cut tall grass from the top
down
Contact dealer to check
damage
Check the plug