edc JAGUAR Guía De Instalación Y Funcionamiento página 6

Trouble Shooting
Pump does not run:
Check fuse and electrical supply
connections.
Check that water is reaching the pump
sensor.
Pump continues to run with no water:
The water sensor can become over
sensitive if contaminated by dirt, mould or
certain cleaning chemicals. If this occurs
the pump may continue to run with no
water. Disconnect the
mains supply and flush the sensor by
pouring clean tap water into the inlet for
around 30 seconds (Fig. 6). If the problem
persists, flush with methylated spirit and
then rinse with water.
Pump is noisy:
Check that the JAGUAR
outlet tube are not vibrating against the
sides of the equipment.
WARRANTY
This product is guaranteed for two years to be free from manufacturing defects or faulty
materials. If it should fail for either of these reasons within two years from the date of
manufacture it will be repaired or replaced free of charge, at the option of EDC
International Limited.
EDC International Limited can accept no liability whatsoever for any loss or damage
arising from the use of this product, however caused. Before using this product the user
should satisfy himself that it is suitable for use in the intended application and for the
manner in which it is intended that it be used.
This product is subject to continuous development and improvement and EDC
International Limited reserves the right to alter the specification or design without prior
notice.
JAGUAR from the
, mains cable and
Pump is pumping air:
Check that the JAGUAR
orientation.
Check that the outlet tube is not syphoning.
In dirty environments an in-line filter is
recommended to avoid pump and sensor
damage.
Fig.6.
is in the correct
GB
5