STEP 5:
Confirm stands are locked in deployed position. Deploy rear stand first.Carefully lower the beam assembly (4) onto the
tongue assembly (1). slide beam forward and lock. Lock the beam into position using lock pin (25). Store second lock
pin in hitch near pivot.
STEP 6:
Connect the end of the 1/2 ID x 38" hydraulic pressure hose (26) coming from the fitting on the pump to the fitting on
the valve. Refer to illustration below.
STEP 7:
Slide one worm gear clamp (27) on the end of the 3/4 x 56" hydraulic return hose (28) that comes from the fitting on the
filter. Then connect the hose to the fitting on the valve. Tighten worm gear clamp. Refer to illustration below.
ITEM
DESCRIPTION
26
Pressure Hose
27
Worm Gear Clamp
28
3/4" Return Hose
Page 12
ITEM
DESCRIPTION
1
Tongue Assembly
4
Beam Assembly
25
5/16 x 3-1/4 Square Lock Pin
QTY
1
1
1
QTY
1
1
2