Automatic Code Search For Some Well-Known Brands; Automatic Code Search For All Brands - Marmitek TV ANYWHERE Modo De Empleo

Ocultar thumbs Ver también para TV ANYWHERE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65

7.3.2 Automatic code search for some well-known brands

If your brand is listed below, you can use the brand search method (faster than the "manual"
and the "automatic code search").
BRAND
Philips/Radiola/Aristona/Erres
Sony/Panasonic/JVC/Sharp/Akai/Toshiba/Daewoo
Thomson/Brandt
Telefunken/Saba/Nordmende
Grundig/Blaupunkt
Nokia/ITT
1.
Turn on the device you want to control.
2.
Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
3.
Press the mode button (3) that matches the device you wish to control. The LED [2] will
flash once.
4.
Enter the code for your brand, point the TV Anywhere Remote at your device and press
Prog+ [5] once. Continue to point the TV Anywhere remote control at your equipment
until the equipment changes Channel. (The remote control transmits an IR signal every
second. Please wait until your device reacts) When your device does react, press ENT [11]
to confirm. If you accidentally go past the code, you can stop the autosearch by pressing
Prog- [5] and by repeatedly pressing this button return to the right code. Press ENT [11]
to confirm.
If some functions of your device do not work, you need to try another code for your
brand. The search function starts after the last confirmed code.

7.3.3 Automatic code search for all brands

When searching an unknown code, you can step through the library automatically
(AutoSearch). When your device responds, you can stop the searching process and store the
code you found.
You can dedicate any device (TV, DVD, SAT...) to the VCR,DVD, ASAT or DSAT buttons.
You first need to enter a code for the type of device you wish to control (from the code
book), i.e. if you want to program a SAT under the VCR button, enter ANY SAT code
from the code book and then follow the steps below:
1.
Turn on the device you want to control.
2.
Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
3.
Press the mode button [3] that matches the device you wish to control. The LED [2] will
flash once.
4.
Press Prog+ [5] once. After a few seconds the remote control will start stepping through
the code library (fast search, 1 code per second). When the device responds, you can
TV ANYWHERE
TM
CODE
1
2
3
4
5
6
1 5

Publicidad

Tabla de contenido
loading

Tabla de contenido