Craftsman 247.889800 Manual De Instrucciones página 8

Installing the Chute
1. Remove the hex washer screws in the chute base. See Figure 4.
2. Align the holes in the chute base with the holes in the lower chute and
secure with the previously removed screws. See Figure 5.
Figure 4
Figure 5
ASSEMBLY
Installing the Chute Rotation Control Assembly
1. Remove the four hex washer screws from the back of the handle (two on
each side). See Figure 6.
2. Using the four hex washer screws, install the chute rotation control
assembly. See Figure 7.
8
Figure 6
Figure 7