Presentation; Area Of Use - Lanaform HEPA E11 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Keep the device away from sources of heat to
prevent the casing melting and causing a fire.
Make sure that the opening of the device and
the power cable do not come into contact
with water, steam or other liquids.
Do not use the device close to highly inflam-
mable gas mixtures or explosives.
Do not attempt to retrieve a device that
has fallen into water. Disconnect the device
immediately.
Do not use the device if it or its accessories
show any signs of damage.
report_p Repairs
Only a specialist may repair electrical de-
vices. Any inappropriate repair may cause a
significant risk to the user. Contact customer
service or an authorised dealer for any repairs.
The fan should not be open.
report_p Fire hazard
Any inappropriate use or use that does not
comply with these operating instructions
may cause a fire hazard! Therefore never use
the air purifier
if it is covered, for example, by a blanket,
cushions, etc.
if it is in the vicinity of petrol or other
flammable materials.
report_p Use
The device must be switched and unplugged
after each use and before it is cleaned.
Do not insert any item into the openings of
the device or into any rotating parts. Make
sure that the moving parts are always capable
of moving freely.
Do not place any item on the device.
Do not expose the device to high temperatures.
Do not expose the device to direct sunlight,
knock it or drop it.
Do not shake the device.
Place the device on a stable, horizontal surface.
Do not dismantle the device entirely.
Do not wash the entire unit with water and do
not immerse it in water. Consult the cleaning
instructions in this manual.
Do not store the product for long periods in
a hot or humid environment.

PRESENTATION

Thank you for choosing the LANAFORM Air
Purifier. The air purifier cleans the ambient air
of dust particles, pollen, animal hair, odours,
harmful gases as well as bacteria and viruses,
using a three-layer filtering system and a
built-in UV light.
E-IM-AirPurifier-001.indd 3
The LANAFORM air purifier:
filters the air using a combined filter
(pre-filter that captures the initial dust
and allergen particles, activated carbon
filter that filters harmful gases and un-
pleasant odours, E11 HEPA filter that filters
fine particles such as dust, smoke, pollen,
allergens, etc.
has a UV light (effective against micro-or-
ganisms such as microbes, germs, viruses,
bacteria and mildew),
is quiet and has four power levels,
has a timer function (two, four or eight hours),
is equipped with a night mode,
is suitable for rooms of approx. 15-20 m²,
has low energy consumption,
switches off automatically as soon as the
casing cover is removed.
Air purifier's operating principle:
1 The air purifier's fan sucks
out the polluted air.
2 The pre-filter filters large parti-
cles such as dust, dirt and hair.
3 Formaldehyde, petrol and other harmful
gases, as well as unpleasant odours,
are then filtered from the ambient
air with an activated carbon filter.
4 Fine particles such as pollen,
allergens, dust and smoke are
filtered through the HEPA filter.
5 The UV light combats micro-or-
ganisms such as microbes, germs,
viruses, bacteria and mildew.
6 The clean air is thrown out into the
ambient air through the exhaust
vent onto the top of the air purifier.
report_p Please note
The filtering performances of the E11 HEPA
filter are ≥95%. In other words, 95% of the
particles (for example, bacteria, viruses and
fine dust) can be filtered.
Unfiltered polluted air may have the follow-
ing effects:
it may cause infections and diseases of
the respiratory tract,
it has a negative impact on health caused
by harmful gases.
DESCRIPTION OF THE
DEVICE [ insert_p 1]
1 Exhaust vent
2 Control screen
3 Casing
4 UV-C light
5 Combined filter
a Pre-filter
b Activated carbon filter
c E11 HEPA filter
6 Base
7 Fastening nut
EN
FR NL DE ES IT CS SL HR
CONTROL SCREEN [ insert_p 2]
1
button:
/
stop
start
Starting/stopping the device.
When the light below the "Filter
Reset" flashes, replace the filter. Once
you have replaced the filter, keep
pressing the
button to put
/
stop
start
the 'change filter' display back to zero.
2
button
ventilation speed
The air purifier has four ventila-
tion speeds: I (low), II (average),
III (high) and IV (turbo)
3 UV light/Night Mode
Press this button once to switch on the
UV light.
Press this button twice to switch on night
mode. The indicator will light up 10 times
before all the indicators switch off. Press
any button to switch on the machine and
standby mode will switch off.
Press this button a third time to switch
off the UV light. The standby mode
indicator will flash 10 times and standby
mode is then switched on again.
Then press this button again
to switch off night mode.
4
button
timer

AREA OF USE

Take out the air purifier
Open the cardboard packaging.
Remove the device upwards, leaving the
protective film behind.
Now remove all the protective film.
Check that the device, mains adapter and
cable are not damaged.
Install the air purifier
Put the air purifier on a flat, solid surface
so that it does not vibrate or make a noise.
report_p Please note
Leave a space of approximately 30cm at least
around the air purifier.
Make sure that the air inlets and exhaust are
never blocked.
INSTRUCTIONS
Switch on the air purifier
1 Follow the instructions in
chapter Assembly.
2 Plug the device into the mains.
Position the power cable so
that nobody trips over it.
3 Press the
button to
/
stop
start
switch on the air purifier
15/06/2018 11:57:17
3
/ 28 English

Publicidad

Tabla de contenido
loading

Tabla de contenido