AllPondSolutions AUTO-PFC-5000 Manual De Instrucciones página 4

ELECTRIC
This unit comes complete with a generous supply of 3 core cable, however
should any additional cable be required, the use of an approved waterproof
cable connector with a proper rating is essential. A cord rated for less amperes
or watts than the appliance rating may overheat.
Please Ensure:
The power supply must be earthed and fused at 3amps.
·
You regularly inspect the cable for damage and deterioration.
·
Do not connect to any voltage other than that stated.
·
You consult a qualified electrician if in doubt about any aspects of
·
wiring.
A residential current device (RCD) is used for additional safety
·
You have complied with Local Electricity Authority regulations if
·
permanently installing to the mains supply.
Please Ensure: The power supply must be earthed and fused at 3amps.
Regularly inspect the cable for damage and deterioration. Consult a qualified
electrician if in doubt about any aspects of wiring.
CHOOSING YOUR FILTER LOCATION
The pressure of your unit depends on many factors such as location (height
·
and distance from your pond), power and location of the connected pump
(L/H), pond depth, stock density and hose dimensions. To enhance pond
water quality, we recommend considering these factors to ensure
maximum efficience and avoid low return pressure.
If positioning your filter above ground, ensure it is located at least 2 metres
·
from your pond edge. If your filter will be sunk into the ground, you can
position the unit closer to the water.
Place your filter on a level and sturdy surface that is well ventilated and not
·
at risk of flooding.
To avoid overheating, ensure the filter is not covered and is positioned away
·
from direct sunlight.
Position the filter so the hosing connected to the Water Inlet Point and
·
Water Outlet Points is not bent or obstructed.