Installation & Use - AllPondSolutions AUTO-PFC-5000 Manual De Instrucciones

The filter is suitable for burying up to the head rim of the unit. Make sure
·
access to the body of the system is possible for maintenance purposes.
Burying the unit will help reduce the distance between the filter and the
pond and provide higher return water pressure.
INSTALLATION & USE
Please read the below instructions carefully before beginning to set up
your filter. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS
COMPLETE AND UNIT IS FILLED WITH WATER.
Prior to installing the unit, examine the quartz sleeve and UV bulb to make
sure these have not been damaged in transportation (see maintenance
section). Handle with care. Do not hold UV bulb with bare hands as this can
affect performance.
Connect the required attachments - Choose the required hosetails
(dependent on your flexible hose dimensions) and attach to the filter (utilise
nut and o-ring in tandem to seal tight). On stepped hosetails if using a hose
larger than the smallest dimension, you will need to cut down the hosetails
to avoid restricting the flow of water.
Position the filter - unless you are burying the unit, ensure that the filter is
placed adjacent to your pond (at least 2 metres away from the water).
Connect your flexible hose to the filter - connect your flexible hose to the
hosetails. Safely connect using either jubilee / wire clips to ensure this is
water tight. Your pump (not included) should be attached to the 'Water Inlet
Point'. The 'Water Outlet Point' should direct water either back into your
pond or to a waterfall adjacent to the pond. Ensure the blue Outlet Control
Dial is pointed towards your 'Water Inlet Point' and 'Water Outlet Point'.
Connect the filter to the mains - Connect the unit to the mains using a
residual current device (RCD) for additional safety.
Switch on your pump - Switch on your pump and visually inspect that you
have the expected water flow through the filter. Visually check that you
have no leakage.
Switch on your filter at the mains - not that you have visually checked that
7
the unit is being supplied with the required flow of water you can turn on
the UV operation by switching on the unit at the mains.