Parts List - Courtyard Creations TMS54GM Instrucciones De Cuidado

PARTS LIST

PART
MATERIAL CODE
NO.
1
TMS54GM-CS10-3
2
TMS54GM-CS04-8
3
TMS54GM-CS04-7
4
TMS54GM-CS10-9
5
TMS54GM-CS10-5
6
TMS54GM-CS05-1
7
27TAN00030
8
27XAA103
Before assembly, open all of the packaged cartons.
Lay out all of the parts on a level, non-abrasive
surface. Open the hardware kit for all of the nuts,
bolts, and washers. Make sure that you have all of
the parts listed. If any parts are missing or
damaged, call the help line at 1-877-539-7436 before
returning this item to the store.
You will need the following tools:
- Phillips Screwdriver (Not included)
- Hex. Key Wrench (See Part #12)
- Hex. Key Wrench (See Part #13)
Note: Parts come in more than one carton.
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
Step 1:
Fasten the frame 2 (#2) and the frame 1 (#3) to the
rear frame (#1) by using bolts (#11). Keep the bolts
loose. See Figure 1.
Note:
The labels marked "2" and "3" on the frames should
coincide with Figure 1 to ensure proper assembly.
V-3
PART Q'TY
REAR FRAME
FRAME 2
FRAME 1
BOTTOM FRAME
FRONT DOOR
TABLE TOP
LOWER CONNECTOR
UPPER CONNECTOR
DO NOT RETURN TO THE STORE!
STOP
PART
MATERIAL CODE
NO.
1
9
1 10
17C40A0709001YX
1 11
17C40A0705001YX
1 12
17KAA0101----Y4
1 13
17KAC3101----Y3
1 14
TMS54GM-CS24-2
1 15
62TMS54GMQ101
1 16
17C17A1506001YX
FIGURE 1
PAGE 3 OF 8
PART
47XA4935
COVER
BOLT M6*25
BOLT M6*15
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 10MM
GLASS
CROSS BRACE
SCREW ST4.8*16
11
1
3
2
15
#11 BOLT M6*15
Q'TY
1
4
10
1
1
1
1
2