Care And Maintenance - Courtyard Creations TMS54GM Instrucciones De Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIFIC WARNINGS:
1) Both children and adults should be aware of the hazards of high surface temperatures and should keep their
distance in order to avoid burns and ignition of clothing.
2) Children should be under adult supervision when in the vicinity of this appliance.
3) Clothing or any other flammable materials should not be hung from or near this appliance.
4) Any guard or protective device removed for servicing the appliance must be replaced prior to use.
5) Installation and repair should be done by a qualified person. The appliance should be inspected before use
and at least annually by a qualified service technician. Frequent cleaning may be required. It is imperative that
the control compartment, burners, and circulating air passageways of the appliance be kept clean at all times.
Read the following switch usage instructions for lighting and
to extinguish:
OPEN
Step 1: Lighting
Open the igniter button and install an AAA battery
(not included), then secure the cap back on. Before
use, make sure that the control knob is in the "OFF"
position. Turn the LP cylinder gas valve to fully open
position. Press down on the control knob and turn
counter clockwise to the "LOW" position. Push in the
gas control knob all the way and hold. Continue to
press the ignition button for 15 seconds.
Note: To extinguish the flame, push the control knob in and rotate clockwise.

CARE AND MAINTENANCE:

1. Do not use aerosol polish or any other flammable
material to clean the burner while it is in use.
2. Inspect and clean the burner regularly. Use a
wire-bristle brush to clean the burner surface.
A straightened paper clip is useful to remove debris
or rust from the small burner ports.
3. Wash frame parts with mild soap and water, rinse
thoroughly, and dry completely. Do not use bleach,
acid, or any other solvents on the frame parts.
4. Inspect and tighten all of the bolts and fasteners on a
regular basis to ensure the proper performance and
safety of your appliance.
5. When not in use, we recommend that it be stored in a
dry and secure area. Always disconnect the LP gas
tank first and store it safely outside.
6. The minimum clearance from the sides, rear, and top of
unit to adjacent combustible construction: 2' (61 cm)
from the sides, 2' (61 cm) from the rear, and 5' (152.5 cm)
from the top.
7. Improper lighting operations will cause serious injury
and explosion.
V-3
Switch Usage Instruction
AAA
OFF
LOW
CLOSE
HI
DO NOT RETURN TO THE STORE!
STOP
OFF
ON
Step 2: Adjusting and Shutting Down
If the burner is not lit, press down the control knob
and turn clockwise to the "OFF" position. Repeat step
1 after 5 minutes. When the burner is lit, press down
the control knob and turn it to the desired heat output
position between "LOW" and "HI". Press down
and turn the control knob clockwise to the "OFF"
position to shut down the appliance. Turn off the
cylinder gas valve.
TYPES OF GAS
Min.Gas supply for input Adj. 25 psi
Maximum Inlet Pressure
Manifold Pressure
Gas Rating
Caution:
The gas pressure regulator provided with this appliance
must be used. This regulator is set for an outlet pressure
of 11 inches water column.
PAGE 6 OF 8
OFF
OFF
LOW
ON
HI
PROPANE GAS
250 psi
11 in.w.c
46,000 Btu/hr

Publicidad

Tabla de contenido
loading

Tabla de contenido