Connect To Electricity And Install The Appliance - Bosch HMB Serie Manual De Instalación

Connect to Electricity and Install the
Appliance
Note: Two people may be needed for this installation.
Insert plug into three-prong, grounded outlet according
to Figure 11. See "Power Requirements" in the section
"Before you begin" for electrical specifications.
Slide the unit back so that the base supports fit over the
baseplate tabs and align with the slots in the rear of the
baseplate.
Secure Microwave in cutout by using two T-20 Torx pan
head screws (B) to connect base supports (E) to base-
plate (I).
Note: Trim Kit attachment latches are vertical on top and
horizontal on the bottom of the Trim Kit.
11