Bluetooth Operation; Led Light Shows; Aux In Operation - lauson CP451 Manual De Usuario

Slide the FUNCTION SWITCH to the "CD/AUX/USB/BT" position.
1.
"USB/BT" button
2. Press
3. If the BOOMBOX has never been paired before or cannot find the last paired device, the
flashing "bt" on LCD will indicate the boombox is in search mode. You need to follow the
pairing instructions below to link the BOOMBOX with your Bluetooth device.

If required, enter the pass code "0000" to pair (link) the BOOMBOX with your device.
4. After successfully pairing (linking), display will change to show "bt" steadily, the Bluetooth icon
also will show in display.
5. After selecting, press PLAY/PAUSE
6. Press or Button on main unit to skip to previous or next song.
7. Press and hold the
device currently paired with BOOMBOX.
Notes: If your Bluetooth enabled device does not support A2DP profile, it will not play the music
through the speaker, even if paired (linked).
 The LED light shows inside the speaker and around the center display of the unit are created
automatically based on the music source being played at the time
 To turn ON/OFF the LED light show, slide LIGHT switch to ON/OFF position.
Note:
If the brightness is glaring, turn on room lights or turn off LED light show
1. Connect the headphone jack of your external device to the AUX IN jack located on the back of
this CD player (The connection cable is not included).
2. Turn on the CD player and slide the FUNCTION SWITCH to CD/AUX/USB/BT position, unit
will enter the AUX function mode once an external device is plugged into the CD/AUX/USB/BT
jack.
3. Start to play your iPod, MP3 player or other external audio device.
4. Slowly adjust both volume controls on your CD player and the external device.
5. Turn off your iPod, MP3 player and etc. when finish listening. Turn the CD player off and
unplug the AUX IN jack.
Remark: Once the AUX IN jack is plugged, the CD player will automatically enter the AUX mode
when the FUNCTION SWITCH is in CD mode. Remember to disconnect the cable from
the unit after use in order to be able to listen to the CD player again.

BLUETOOTH OPERATION

long time to change BT mode
Button on the unit to play or pause the song.
STOP/PAIR Button for 3 seconds or turn off the Bluetooth function of

LED LIGHT SHOWS

AUX IN OPERATION

7
EN