How To Use - Panasonic EW1611 Instrucciones De Operación

How to use

On sink
1 Place the main unit on a flat and stable
surface.
2 Plug in the power plug.
• The power cord can be
pulled out from either the
right or the left.
1. Open the water tank cap, remove
the water tank, and fill it with water.
• Always use new tap water or lukewarm
water.
• If the water feels cold, use lukewarm water
with a temperature of 40 °C (104 °F) or less.
• When filling water, be sure not to exceed
the upper water level limit.
2. Set the tank to the main unit firmly,
and attach the water tank cap.
3. Insert the nozzle firmly into the
handle until it clicks. Make sure it
is fixed firmly.
PB014814 - EW1611W551 _(01EN)_05-11-17.indd 9
4. Select the water pressure level.
• Ensure the Stop/Jet switch is set to
" " (Stop)
1 Press the power switch " ".
(The water pressure level
LED indicator lights on.)
• The power will be cut off after
about 10 minutes to avoid
forgetting to turn off. (This function
is to avoid forgetting cutoff.)
Upper water
level limit
2 With the nozzle facing the basin,
set the Stop/Jet switch to "
(Jet mode) to jet water.
3 Press "+" or "-" on the water
pressure regulator switch
until the desired flow intensity
is reached.
• Keep pressing "+" or "-" will
continuously change the
water pressure.
4 Set the Stop/Jet switch to " " (Stop) to stop jetting
temporarily.
• Do not leave the product in the " " (Stop) state for more
than 1 minute. (May cause malfunction.)
Stop/Jet switch
"
Level 10
Level 2
Level 1
9
2017/5/11 16:04:22