Wiring Connections - QSC AcousticPerformance Serie Guia Del Usuario

Wiring the AcousticPerformance Loudspeaker
WARNING!: Make sure the amplifi ers are turned off, and disconnected from the power source, or the loudspeaker wiring is not
connected to the amplifi ers.
Refer to Figure 7, Figure
The pin numbers for the NL4 connector correspond to the pin numbers on the barrier strip.
Model AP-5122m utilizes NL4 connectors only.
Wiring
Refer to Figure 7 and Figure 9
1. Make sure the loudspeaker is set to the desired mode. Refer to
ENG
"Changing from Passive to Bi-amp" on page 5.
1. Connect the wiring (10 AWG maximum) to the correct terminals
if you are using the barrier strip.
Pin-out for the barrier strip and the NL4 connectors:
• Passive Mode:
◦ 1+ and 1-
• Bi-amp Mode:
◦ LF 1+ and 1-
◦ HF 2+ and 2-
NOTE: The loudspeakers can be daisy-chained, in
parallel, using one of the inputs as the output to the
next loudspeaker.
TD-000369-00-B
8, and Figure 9.
Model Size
AP-5102 10" Two-way NL4 and covered 4-pin barrier strip
AP-5122 12" Two-way NL4 and covered 4-pin barrier strip
AP-5152 15" Two-way NL4 and covered 4-pin barrier strip
AP-5122m 12" Two-way Dual NL4

Wiring Connections

Passive mode
Pos Neg
1+ 1-
— Figure 7 —
6
Wire Size Maximum
10 AWG
Bi-Amp mode
Pos Neg
LF
1+ 1-
— Figure 8 —
1+
1-
2+ 2-
— Figure 9 —
Pos Neg
HF
2+ 2-