Parts - Nostalgia Products Kegorator KRS2100 Serie Manual De Instrucciones

PARTS

Read all instructions carefully before assembling the KEGORATOR
IMPORTANT! Stand the KEGERATOR
hours before plugging into an electrical outlet. This will allow the coolant
in the regfrigeration unit to stabilize before turning on the power.
If still unsure whether your KEGORATOR™ has been properly assembled,
it is recommended that you contact customer service, or a qualified
installer, such as a brewery or wherever kegs are sold.
Washers / Beer Line Adapter Parts
NOTE: Most washers are already attached to the KEGORATOR
are included in a plastic bag. Refer to the parts diagram and corresponding
numbers to see where the washers/beer line adapter parts belong.
(6) Body Seal Coupler (6) Probe Seal Coupler
Washer (38 mm)
(1) Tap Tower
Washer (24 mm) Handle Washer (15 mm)
Beer Line Adapter Parts
If you wish to use a CO 2 Line other than the one provided, the following parts
are included to connect your CO2 Line from the Keg Coupler to CO 2 Tank.
Additional parts not included may be necessary to complete your setup.
(6) CO 2 Line
Adapter Hex Nut
in an upright position for 8-10
TM
Washer (22 mm)
(1) Tap Tower Spigot (1) Tap Tower Spigot
(6) CO 2 Line
Adapter Nipple
.
TM
. Extra parts
TM
(6) Inner Probe (6) Top Coupler
Seal Coupler Washer (20 mm)
Washer (23 mm)
(9) Regulator High
Washer (13 mm) Pressure Washer
(6) Hose Clamps
(18 mm)
6