ScorpionExo EXO-TECH Manual De Instrucciones página 5

Closing the
EN
Flip-back Chin Bar
A
B
7
Lift up the chin bar using the rest of fingers (B)
while pushing the back of the helmet (A) with your
thumb. Then the chin bar will be able to rotate.
Rotate the chin bar until the chin bar is closed. If the
shield is lowered, it will be automatically opened
while rotating the chin bar.
The shield is not automatically closed. You need to
close it manually.
WARNING
Be sure to hear the "click" sound to check the two
hooks (positioned in red circled area of each side) are
properly latched, and the chin bar is securely closed.
This is very important for your safety.
Faceshield
Replacement
First, fully open the face shield.
When the face shield is fully opened, put your thumbnail (or
tools like a flat screwdriver) into the dent of the latch (in the
red circle) and lift it up.
When the latch is opened, slightly lift up the shield and pull it out.
Repeat the same process to release the opposite side.
Reverse the process to install the face shield.
NOTE: FOR SAFETY REASON, THE RATCHET SHOULD NOT BE DISASSEMBLED BY USER.
IT IS RECOMMENDED TO CONTACT YOUR SCORPION DEALER OR WARRANTY CENTER IF
IT IS NECESSARY TO DISASSEMBLE THE RATCHET TO REPAIR YOUR HELMET.
WARNING
DO NOT attempt to adjust while riding.
EN
8