Connecting To Remote Devices; Balanced Line Application; Figure 2 Connections On The Back Of Model 300Scw-1; Figure 3 Model Am25Ck Connections (Balanced Line) - Federal Signal SelecTone 300SCW-1 Manual De Instalación Y Mantenimiento

Installation and Maintenance Manual
1 2 3 4 5 6
SHIELDED
TWISTED PAIR
SIGNAL LINES

Connecting to Remote Devices

Physically install the remote SelecTone device(s) following the instructions included with the device.

Balanced Line Application

For 300GC, 300GCX, 300X, 302GC, 302GCX, 302X or 50GC speakers, an AM25CK Connector Kit is
required for connection to the balanced signal output of the 300SCW-1. The AM25CK properly terminates
the balanced signal lines to the amplifier in the 300GC, 300GCX, 300X, 302GC, 302GCX, 302X and
50GC. As shown in Figure 3, connect the white input wires on the AM25CK to the terminals TB1-4 and
TB1-5 of terminal block TB1 on the 300SCW-1. The AM25CK and AM70CK Connector Kits are NOT
polarity sensitive, but polarity must be observed when placing speakers in close proximity to each other.
12

Figure 2 Connections on the back of Model 300SCW-1

7 8 9 10 11 12 13 14 15 16 17
TB1
CLASS II FIELD
WIRING COMPARTMENT

Figure 3 Model AM25CK connections (balanced line)

300GC
AM25CK
TERMINAL BLOCK (TB1)
ON REAR OF 300SCW-1
Model 300SCW-1 Wall-Mounted Command Unit
KNOCKOUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
TB2
FROM EXTERNAL
SWITCHING DEVICES
300GC
AM25CK
4 5
SHIELDED TWISTED PAIR
SIGNAL LINE TO ADDITIONAL
SELECTONES
ACCESS HOLE FOR
POTENTIOMETER ADJUSTMENT
CLASS I FIELD
WIRING COMPARTMENT
290A7338
AC POWER IN
290A7337