Daintree GE current LIS Serie Guia De Instalacion página 14

Lumination LIS Series
®
Troubleshooting
Symptom
Luminaires will not turn on
Luminaire on through wiring
will not turn on
Luminaire to luminaire mating in
continuous run is loose
Suspension methodwon't engage
with luminaire
This device complies with Part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) This device may not cause harmful
interference,and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class [A] RFLD
complies with the Canadian standard ICES-005. CeDEFRde la classe [A]est conformeà la NMB-005du Canada.
Note: This equipment has been tested and found to comply with the limits for a Class Adigital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residentialarea is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Solution
• Check that the color of the supply side wires match the color of the wires they are connected to.
• Check that the LED driver connector is fully engaged to the LED light engine connector.
• Check that the through wiring connector from the previous fixture in the linear row is fully engaged
to the malfunctioning luminaire.
• Ensure that both upper and lower connecting features are correctly engaged.
• Ensure that through wires are correctly routed in the wiring notch.
• Check that the suspension method is one of the approved types in the installation instruction.
www.gecurrent.com
© 2020 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
IND095 ENG (Rev 08/19/20) A-1013796
Installation Guide